30
HOW TO USE THE BUILT-IN TIMER
Timer playback
1
Press the ON/STAND-BY button to turn the power
on.
2
Press the CD, TUNER (BAND), TAPE (1 2) or
VIDEO/AUX button to select the desired function,
and then adjust the sound volume using the VOL-
UME buttons.
3
Press the TIMER/SLEEP button repeatedly until a
white " " is displayed.
The timer set indicator will flash.
4
Press the TUNING/TIME ( or ) button to set the
hour start time, then press the MEMORY/SET but-
ton.
5
Press the TUNING/TIME ( or ) button to set the
minute start time, then press the MEMORY/SET but-
ton.
The unit will enter the stand-by mode automatically, and
the timer set indicator will light up.
6
When the preset time is reached, the timer playback
will start.
The volume will increase gradually.
7
If you select CD or TAPE, the unit will enter the
stand-by mode after the playback. If you select
TUNER or VIDEO/AUX, it will enter the stand-by
mode one hour after the timer playback starts.
To cancel timer operation:
Press the ON/STAND-BY button to turn the power on.
To change the programmed contents:
Start again from step 1.
Notes:
When performing timer playback using an external unit
connected to the VIDEO/AUX sockets, only the power of
the main unit will enter the stand-by mode automatically.
(The power of the external unit will not be turned off.)
Once the time is set, the setting will be retained until a
new time is entered.
The unit will turn on and play the selected source at the pre-
set time.
Before setting the timer, make sure that the clock setting
is correct (page 10).
(Main unit operation)
ON/
STAND-BY
TIMER/
SLEEP
CD
TUNER/(BAND)
TAPE
(1
2)
VIDEO
/AUX
MEMORY/SET
VOLUME
TUNING/
TIME
(
)
To Next Page
Loading...
