25
(Continued)
EON-TI
1
Tune in the desired RDS station (whilst a station
name is displayed).
2
Press the EON button when "EON" appears.
"PTY TI" and "SELECT" will appear alternately for about
6 seconds.
3
Whilst they are displayed, select the TI (Traffic Infor-
mation) using the PRESET ( or ) button.
The selected "TI" will flash.
4
Within 4 seconds, press the PTY.TI SEARCH button.
"TI" and "WAITING" will appear for 2 seconds each.
"TI" will appear, and the unit will enter the EON-TI stand-
by mode.
5
When a TA specified starts on an ON (other network)
station, the unit will automatically switch to that sta-
tion, and "TI" will flash.
6
When the traffic announcement is over, the unit will
automatically return to the original station you were
tuned to.
Note:
If the EON button is pressed when "EON" is not dis-
played, "NO EON" will appear for 5 seconds to indicate
that the unit cannot enter the EON stand-by mode.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON button.
("TI" "WAITING")
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON button.
Within 4 seconds, press it again. The EON stand-by mode
will be cancelled.
"TI" will go out.
Note:
If neither "TP" nor "TA" appear, then even if "EON"
appears, the unit cannot enter the EON-TI stand-by
mode. In this condition, if the PTY.TI SEARCH button is
pressed after TI is selected, "NO TI" will flash for 4 sec-
onds.
(Main unit operation)
2
3
4
To Next Page
Loading...
