03/2/10 CD-E200H(H)E2.fm
E-15
ENGLISH
CD-E200H
Radio
Listening to the radio
" Tuning
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "ST" indicator.
!
" " will appear when an FM broadcast is in stereo.
!
If the FM reception is weak, press the TUNER (BAND) button to
extinguish the "ST" indicator. The reception changes to monau-
ral, and the sound becomes clearer.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the
desired frequency band (FM or AM).
3
Press the TUNING/TIME ( or ) button to tune in to the de-
sired station.
Manual tuning:
Press the TUNING/TIME button as many times as required to
tune in to the desired station.
Auto tuning:
When the TUNING/TIME button is pressed for more than 0.5
seconds, scanning will start automatically and the tuner will
stop at the first receivable broadcast station.
Notes:
!
This can be operated by pressing the TUN. ( or ) button
on the remote control.
!
When radio interference occurs, auto scan tuning may stop
automatically at that point.
!
Auto scan tuning will skip weak signal stations.
!
To stop the auto tuning, press the TUNING/TIME button
again.
!
When an RDS (Radio Data System) station is tuned in, the
frequency will be displayed first, and then the RDS indicator
will light. Finally, the station name will appear.
!
Full auto tuning can be achieved for RDS stations "ASPM",
see page 22.
FM stereo mode indicator
FM stereo receiving indicator
To Next Page
Loading...
