03/2/10 CD-E200H(H)E2.fm
E-19
ENGLISH
CD-E200H
Tape Recording
Recording to a cassette tape (continued)
To perform programmed recording:
To interrupt recording:
Press the REC PAUSE (TAPE-2 ) button.
"
Recording is paused, but CD playback will continue.
To resume recording, press the / button.
To stop recording:
Press the button.
The CD and tape will stop.
Note:
Whilst recording, OPEN/CLOSE button is deactivated. It is recom-
mended to perform CD recording after closing the disc tray.
! Recording from the radio
To interrupt recording:
Press the REC PAUSE (TAPE-2 ) button.
To resume recording, press the / button.
To stop recording:
Press the button.
Note:
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
! Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
To stop dubbing:
Press the button.
TAPE 1 and TAPE 2 will simultaneously stop.
! Erasing recorded tapes
Note:
Make sure that the TAPE 1 is not in use.
1 Programme discs and tracks. (See page 14.)
2 Press the REC PAUSE (TAPE-2 ) button.
3 Press the / button.
1
Tune in to the desired station. (See page 15.)
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the REC PAUSE (TAPE-2
) button.
Recording will be paused.
4
Press the / button to start recording.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette
into the TAPE 1 cassette com-
partment. Insert a blank tape
into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1 2) button until "TAPE 1" appears on
the display.
4
Press the REC PAUSE (TAPE-2
) button.
Recording will be paused.
5
Press the / button to start dubbing.
1 Load the tape to be erased into the TAPE 2 cassette compart-
ment with the side to be erased facing toward you.
2 Press the TAPE (1 2) button until "TAPE 2" appears on the dis-
play.
3 Press the REC PAUSE (TAPE-2 ) button.
4 Press the / button to start erasing.
To Next Page
Loading...
