Sharp CD-E200H - Maintenance; Specifications

03/2/10 CD-E200H(H)E3.fm
E-31
ENGLISH
CD-E200H
References
Maintenance
" Cleaning the tape-handling parts
!
Dirty heads, capstans or pinch rollers can cause poor sound and
tape jams. Clean these parts with a cotton swab moistened with
commercial head/pinch roller cleaner or isopropyl alcohol.
!
When cleaning the heads, pinch rollers, etc., unplug the unit
which contains high voltages.
!
After long use, the deck's heads and capstans may become mag-
netised, causing poor sound. Demagnetise these parts once
every 30 hours of playing/recording time by using a commercial
tape head demagnetiser. Read the demagnetiser's instructions
carefully before use.
" Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap
solution, then with a dry cloth.
Caution:
!
Do not use chemicals for cleaning (petrol, paint thinner, etc.). It
may damage the cabinet finish.
!
Do not apply oil to the inside of the unit. It may cause malfunc-
tions.
Specifications
As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification fig-
ures indicated are nominal values of production units. There may be
some deviations from these values in individual units.
" General
" Amplifier
Playback head Erase head
Capstan Recording/Playback head
Pinch roller
TAPE 1
TAPE 2
B
C
A
D
B
C
E
Power source AC 230 V, 50 Hz
Power
consumption
Power on: 70 W
Power stand-by: 0.6 W (*)
Dimensions Width: 270 mm (10-5/8")
Height: 305 mm (12")
Depth: 342 mm (13-1/2")
Weight 6.4 kg (14.1 lbs.)
( * )This power consumption value is obtained when the demonstra-
tion mode is cancelled in the power stand-by mode. Refer to
page 8 to cancel the demonstration mode.
Output power PMPO: 200 W
MPO: 100 W (50 W + 50 W) (DIN 45 324)
RMS: 66 W (33 W + 33 W) (DIN 45 324)
RMS: 50 W (25 W + 25 W) (DIN 45 500)
Output terminals Speakers: 6 ohms
Headphones: 16 - 50 ohms (recommended:
32 ohms)
Input terminals Video/Auxiliary (audio signal): 500 mV/47 k
ohms