03/2/10 CD-E200H(H)E2.fm
E-17
ENGLISH
CD-E200H
Tape Playback
Listening to a cassette tape (TAPE 1 or TAPE 2)
Before playback:
Playback is possible in the TAPE 1 compartment as well as the
TAPE 2 compartment.
To stop playback:
Press the button.
Fast forward/rewind: (TAPE 2 only)
Caution:
"
To remove the cassette, press the button, and then open the
compartment.
"
Before changing from one tape operation to another, press the
button.
"
If a power failure occurs during tape operation, the tape head will
remain engaged with the tape and the cassette door will not
open. In this case, wait until the power is restored.
"
Even if the button on the remote control is pressed during tape
playback, the unit will not enter the pause mode.
"
For playback, use normal or low-noise tapes for
the best sound. (Metal or CrO tapes are not rec-
ommended.)
"
Do not use C-120 tapes or poor-quality tapes, as
they may cause malfunctions.
"
Before loading a tape into the cassette compartment,
tighten the slack with a pen or a pencil.
1
Press the ON/STAND-BY button to turn the power on.
2
Open the cassette door by pushing the area marked "PUSH
EJECT ".
3
Load a cassette into the TAPE 1
compartment or TAPE 2 compart-
ment with the side to be played
facing toward you.
4
Press the TAPE (1 2) button to select the cassette you
want to listen to.
5
Press the / button to start playback.
1 Press the button, then press the TAPE (1 2) button to select
TAPE 2.
2 To advance the tape, press the button. To rewind it, press
the button.
TAPE 1
TAPE 2
To Next Page
Loading...
Need help?
General
