04/1/28 CD-SW440N_09 EN
E-9
Listening to the iPod (continued)
Simply remove the iPod from the iPod dock. It is safe to do
so even during playback.
Note:
When navigating the iPod menus with remote control, do
not operate any of the buttons on the iPod unit. The volume
level is adjusted by pressing the VOL (+ or –) button on the
main unit or the remote control. Adjusting the volume on
the iPod unit gives no effect.
iPod operation:
The operations described below depend on the generation
iPod you are using.
System on operation:
When the main unit is powered on, the iPod unit will
automatically power on when docked in the unit (including
TIMER function/exclude USB function).
System off (stand-by operation):
When the main unit is turned to stand-by mode, the docked
iPod unit will automatically turn to stand-by mode.
Notes:
● If the TV Out setting is already turned on at video menu,
the video is automatically displayed on the TV screen
when ENTER key is pressed.
● To return to watching video on iPod screen, press the
MENU button to enter video menu. Then press the
DISPLAY (TV OUT) button for more than 2 seconds
until “iPodDISP” appears.
● During iPod video playback, pressing the DISPLAY (TV
OUT) button will not toggle video out display between
iPod and TV.
iPod playback detection function:
Once the play button on the iPod unit is pressed, the main
unit will automatically change to iPod function overriding
the previous function selected.
Caution:
● Unplug all accessories for the iPod before inserting it
into the iPod dock.
● Stop button ( ) at main unit is invalid during iPod
function.
Insert the tip of a screwdriver (“–” type, small) into the
iPod adaptor hole as shown and lift upward to remove.
1 Press the MENU button to view the menu on iPod unit.
Press it again to go back to previous menu.
2 Use the TUNING ( or ) button on the remote
control to select an item on the menu and then press
ENTER button.
1 Press the DISPLAY (TV OUT) button for more than 2
seconds.
“TV DISP” will appear on display.
2 Press the ENTER button to start playback.
To remove iPod adaptor
To disconnect iPod
Navigating the iPod menus
Watching videos on a TV connected to
iPod
Function Main
unit
Remote
control
Operation
Play Press in the pause
mode.
Pause Press in the playback
mode.
Track up/
down
____
Press in the playback or
pause mode.
If you press the button in
the pause mode, press
the / button to start
the desired track.
Fast
forward/
reverse
____
Press and hold down in
the playback mode.
Release the button to
resume playback.
Display
____
iPod back light ON.
Press for more than 2
seconds to toggle the
video out display
between iPod or TV.
Repeat
____
Press to toggle repeat
mode.
Shuffle
____
Press and hold down to
toggle shuffle mode.
iPod
Menu
____
Press to view the iPod
menu during iPod
function.
iPod
Enter
____
Press to confirm the
selection.
iPod
Cursor
Up/Down
____
Press to select the iPod
menu.
Various iPod functions
To Next Page
Loading...
Need help?
General
