103
Manual VAT 1 system (Manual entry method for subtotals that uses VAT 1 preset percentages)
This system enables the VAT calculation for the then subtotal. This calculation is performed using the VAT 1
preset percentages when the
◊
key is pressed just after the
:
key. For this system, the keyed-in tax rate can
be used.
Manual tax 1-6 system (Manual entry method using preset percentages)
This system provides the tax calculation for taxable 1 through 6 subtotals. This calculation is performed using
the corresponding programmed percentages when the
◊
key is pressed just after the
:
key.
After this calculation, you must finalize the transaction.
Automatic VAT 1-3 and automatic tax 4-6 system
This system enables the calculation in the combination with automatic VAT 1 through 3 and automatic tax 4
through 6. The combination can be any of VAT1 through VAT3 corresponding to taxable 1 through taxable 3 and
any of tax 4 through 6 corresponding to taxable 4 through taxable 6 for each item. The tax amount is calculated
automatically with the percentages previously programmed for these taxes.
• A PLU not programmed for any of the tax statuses is registered depending on the tax status of
the department which the PLU belongs to.
• VAT/tax assignment is printed at the fixed right position near the amount on the receipt as
follows:
VAT1/tax1 A
VAT2/tax2 B
VAT3/tax3 C
VAT4/tax4 D
VAT5/tax5 E
VAT6/tax6 F
When the multiple VAT/tax is assigned to a department or a PLU, a smaller number of the VAT/tax
will be printed. For details, contact your authorized SHARP dealer.
550
4
:
◊
;
PrintKey operation
To Next Page
Loading...
