122
To prevent the register from moving when the drawer opens, the fixing angle bracket is supplied with the
register. By attaching the bracket to the table where the register is installed, you can hook the register on this
bracket and secure the register to its position.
How to install the fixing angle bracket
1.
Thoroughly clean the location where the fixing angle
bracket (B) is to be placed.
2.
Peel off the adhesive tape on the fixing angle bracket.
3.
Hook the angle bracket onto the hook (A) that is
located at the bottom rear of the register.
4.
Firmly stick the fixing angle bracket to the table
surface that your cleaned above.
How to remove the register from the fixing angle bracket
1.
Lift up the front of the register and pull the register
towards you.
Installing the fixing angle bracket
9
To Next Page
Loading...
Need help?
General
