ER-A520/ER-A530 REPORT MODES (OP X/Z, X1/Z1 and X2/Z2)
4 – 2
JOB# : ‘x’ is 1 for X1/Z1 mode, 2 for X2/Z2 mode, and 0 or nothing for OPX/Z mode.
FLASH READING REPORT
*2 To read respective reports, it is necessary to follow the procedure
below.
*3 To read respective reports, it is necessary to follow the procedure
below.
*4 The Report range can be specified by entering the starting and end-
ing numeric entries numbers according to the following procedure.
*5 Individual server/cashier report BILL NO. (4 digit) the assigned
server/cashier.
*6 When the server/cashier code is not entered, the report is issued
only when there is an assigned server. Otherwise a server code
must be entered to issue the report.
GLU/PBLU x80
oo
PBLU CODE
*
4
GLU/PBLU (SERVER) x81
oo
SERVER CODE
*
6
CLOSE GLU/PBLU x82
oo BILL NO. *4
CLOSE GLU/PBLU (SERVER) x83
oo SERVER/CASHIER CODE *6
STACK REPORT x90
oooo *8
NON ACCESSED UPC x05
o *2
NON ACCESSED
UPC DELETE (ALL)
x05
o
*
2
NON ACCESSED
UPC DELETE (PICK UP)
x05
o
PICK UP *11
REPORT NAME KEY ENTRY
MODE
DATA FOR READINGOPX/Z X1/Z1 X2/Z2
XZX1Z1X2Z2
DEPARTMENT [DPTn]
o *9
DEPARTMENT XX [DEPT#]
o XX = DEPT CODE (2 digit) *9
CID [X]
o *9
PAID TOTAL [SBTL]
o *9
REPORT NAME JOB#
MODE
*
1
DATA FOR READINGOPX/Z X1/Z1 X2/Z2
X Z X1 Z1 X2 Z2
*1 MODE: X: Daily operator X report Z: Daily operator Z report
X1: Daily X report Z1: Daily Z report
X2: Periodic X report Z2: Periodic Z report
(X report) : The corresponding data is held in the ECR.
(Z report) : The corresponding data is cleared in the ECR.
(DATA): GROUP No. (2 digit)
DEPT CODE (2 digit)
JOB#
(X report)
Reading
Resetting
(Z report)
@/FOR
CA/AT
JOB#
DATA
(X report)
Reading
Resetting
(Z report)
@/FOR
CA/AT
(START NO.) and (END NO.): PLU CODE (6 digit)
PRICE (6 digit)
TIME (2digit) (24-hour entry in spite
of TIME SYSTEM)
PBLU CODE (4 digit)
JOB#
START NO. END NO.
Reading
Start = End
Resetting
All
@/FOR
@/FOR
CA/AT
JOB#
SERVER CODE
Reading Assigned server/cashier
4 digitResetting
@/FOR
CA/AT
To Next Page
Loading...
