83
KEY OPERATOR PROGRAMS
The key operator programs are used to prohibit changes to the [Condition Settings]
and to configure interface settings.
• Default Settings (p.79): Select the setting for which you wish to prohibit changes.
• Interface settings (p.84): Enable monitoring of data sent to the network port and
set restrictions.
Configuring a setting in the key operator programs
1
Click [Key operator programs] in
the menu frame.
The "Default Settings" screen of the [Key
operator programs] will appear. If you wish
to select a setting in the "Default Settings"
screen, go to step 3.
2
Click the desired setting.
3
Make a selection for the setting in the screen that appears.
See "Key operator programs" (p.84) for descriptions of the settings.
4
Click [Submit] to store the entered information.
To Next Page
Loading...
