Sharp FO-A660

Transfer Function
36
4 Press and speak into the handset to record the message.
• The transfer message can be up to 15 seconds long. While recording, the
display will show the time left to record.
5 When finished, replace the handset or press .
START/MEMOR
Y
STOP
Checking or erasing the transfer message
To check or erase the transfer message, follow Steps 1 and 2 of the above
procedure, and then press to check the message, or to erase
the message.
PLAY/
HOLD
D
ELET
E
Turning the Transfer function on and off
When you go out and wish to use the Transfer function, turn it on as follows:
1 Press once and once.
2 Press once and 3 times.
3 Press .
4 Press to turn on the Transfer
function.
(Press to turn the function off.)
5 Press to return to the date and time display.
FUNCTION
1
2
STOP
TRANSFER FUNC
Display:
A.M. SETTING
1=YES, 2=NO
The display briefly shows
your selection, then:
ON A.M. FAILURE
all.book Page 36 Monday, September 29, 2003 4:48 PM