E-8
Gently remove dust from the back panel,
using a vacuum cleaner attachment or
similar tool.
BACK PANEL
(Pre-lter)
To maintain optimum performance of this air purier, please clean the unit including the lter
periodically.
Be sure to disconnect the power cord from the wall outlet before performing any maintenance.
CARE AND MAINTENANCE
Back Panel
UNIT
CAUTION
NOTE How to clean hard to remove dirt
1. Add a small amount of kitchen detergent
to water and soak for about 10 minutes.
2. Rinse off the kitchen detergent with clean
water.
3. Completely dry the lter in a well-
ventilated area.
Wipe with a dry, soft cloth
For stubborn stains or dirt, use a soft cloth dampened with warm water.
•Do not use volatile uids
Benzine, paint thinner, polishing powder, etc. , may damage the surface.
•Do not use detergents
Detergent ingredients may damage the unit.
SENSOR
1. Remove the Back Panel.
2. Remove the Dust Sensor Filter.
3. If it is very dirty, wash it with water and dry it
thoroughly.
Dust sensor
lter
Back Panel
Do not apply excessive pressure, when
scrubbing the back panel.
CAUTION
OM_FP-F40E_40L_EN_MA_CS.indb 8 4/21/2558 BE 3:12 PM
To Next Page
Loading...
Need help?
General
