OPERATION
MAIN UNIT OPERATION
Plasmacluster Indicator Light
MODE Button
E-8
Power ON/OFF Button
AUTO operation
The fan speed is automatically switched
(HIGH*, NORMAL, SILENT) depending
on the amount of pollution in the air. The
sensors detect the pollution for efficient
air purification.
15 min. HIGH* operation
The unit will operate at HIGH* fan speed
for 15 minutes, then will operate at Auto
operation.
The operation mode is effective when
quick removal of impurities in the air is
desired.
POLLEN mode operation
The unit will operate at HIGH* fan speed
for 10 minutes, then will alternate
between NORMAL and HIGH for 20
minutes.
10 minutes: HIGH fan speed
20 minutes:
NORMAL fan speed
20 minutes: HIGH fan speed
Main Unit Controls
• AUTO
• 15 min. HIGH
• POLLEN
• SILENT
• NORMAL
• MAX
Clean-Sign Light
Power ON/OFF Button
• Used to start operation (short beep) and stop operation (long beep)
• Plasmacluster Indicator Light and Fan Speed Indicator Light turn on/off.
• Unless unplug the power cord, the operation starts in the previous mode the unit
was operated in.
MODE Button
• The operation mode can be switched.
* HIGH fan speed is an
intermediate speed
between NORMAL
and MAX.
1
2
NORMAL operation
The unit will operate at a fan
speed of NORMAL.
MAX operation
The unit will operate at a fan
speed of MAX.
SILENT operation
The unit will operate quietly
using minimal air intake.
Filter Indicator Light
1
2
To Next Page
Loading...
Need help?
General
