Sharp HT-CN400DVH

– 11 –
HT-CN400DVH/HT-CN400DVE/HT-CN500DVH/HT-CN500DVE
• Parts marked with “ 1 ” ( ) are important for
maintaining the safety of the set. Be sure to replace these
parts with specified ones for maintaining the safety and
performance of the set.
NOTES ON SCHEMATIC DIAGRAM
• Resistor:
To differentiate the units of resistors, such symbol as K and
M are used: the symbol K means 1000 ohm and the symbol
M means 1000 kohm and the resistor without any symbol is
ohm-type resistor. Besides, the one with “Fusible” is a fuse
type.
• Capacitor:
To indicate the unit of capacitor, a symbol P is used: this
symbol P means pico-farad and the unit of the capacitor
without such a symbol is microfarad. As to electrolytic
capacitor, the expression “capacitance/withstand voltage”
is used.
(CH), (TH), (RH), (UJ): Temperature compensation
(ML): Mylar type
(P.P.): Polypropylene type
• Schematic diagram and Wiring Side of P.W.Board for this
model are subject to change for improvement without prior
notice.
• The indicated voltage in each section is the one measured
by Digital Multimeter between such a section and the chas-
sis with no signal given.
1. In the tuner section,
indicates AM
indicates FM stereo
2. In the power section, a tape is being played back.
REF. NO
DESCRIPTION
POSITION
TA301 ON/STAND-BY ON—OFF
TA302 STOP ON—OFF
TA303 FAST FORWARD ON—OFF
TA304 FAST REVERSE ON—OFF
TA305 VOLUME DOWN ON—OFF
TA306 MODE ON—OFF
TA307 FUNCTION ON—OFF
TA308 VOLUME UP ON—OFF
TA309 PLAY ON—OFF
TA310 OPEN/CLOSE ON—OFF
TYPES OF TRANSISTOR AND LED
(1) (2) (3)
(S) (G) (D)
E C B
FRONT
VIEW
(S) (D) (G)
E B C
FRONT
VIEW
B C E
FRONT
VIEW
KER00022SK192 A
PN222 A
2SC2001 L 2TIP122 DDTC114 ECA
CM5783 GR
2SC1009 A
2SC1623
CM5051
2SA812
FRONT
VIEW
B
(3)
E
(1)
C
(2)
TOP
VIEW