– 10 –
HT-CN400DVW/HT-CN400DVA/HT-CN500DVW/HT-CN500DVA
Instrument
Connection
Test Stage Frequency Frequency
Display
Setting/
Adjusting
Parts
AM IF 450 kHz 1,620 kHz T008 *1
AM Band — 522 kHz (fL): T003 *2
Coverage (fH):TC002
AM Tracking 990 kHz 990 kHz (fL): T002 *1
(fH): TC001
1. How to show Version number.
A. Door Open,
B. Press and hold R/C "Volume up" Button;
C. Press R/C "Zoom" button continue,
D. OSD show version number,
VER
xxxx x PAL xx x xx
Month and day version TV TYPE Tuner area region code LANGUAGE
The first
xxxx stand for month and day, the second x stand for version sequence, the third x stand for TV system, the forth
xx for tuner area, the fifth x stand for region code. The sixth code xx stand for language.
2. How to adjust TUNER AREA.
A. Door Open
B. Press and hold R/C "Volume up" button;
C. Press R/C "Subtitle" button continue;
D. OSD show "Tuner Area: xx
Press Down button to select
Press OK button to confirm"
E. Then use R/C
to select tuner area you want (EUR USA cyclically), then press " OK" to confirm,
F. If OK button is pressed in five seconds, OSD will show "Tuner Area Change"; If you didn't press it in five seconds, the system
will remain original status.
3. How to select region code;
A. DVD door open
B. Press and hold R/C "Volume up" button;
C. Press R/C "Language" button;
D. TV shows region code
E. Cyclically press Up/Down button to select region code 0 1 2 3 4 5 6 0
F. Press " Enter" button to save the region code. If no press "Enter" button in five seconds, then the region code remain original
status.
4. How to select OSD Language Sequency,
A. Door close and no disc,
B. Press and hold R/C "Volume up" button;
C. Then Press R/C "Subtitle" button;
D. OSD show last setting "OSD language", (English France German Italian Spanish).
E. Then use
button to select language that you want and its sequence.
F. For example: default language is English, you select English and press Enter button, then its sequence is change to
(English France German Italian Spanish)
••
••
•
AM IF/RF
Signal generator: 400 Hz, 30%, AM modulated
TUNER SECTION
fL: Low-range frequency
fH: High-range frequency
Figure 10 TUNER ADJUSTMENT POINTS
ADJUSTMENT
• FM IF
Notes:
1: Description of the "FM IF Adjustment" is not carried on this
Manual. It is because the IF coil in the FM front end section
has been best adjusted in the factory so that its further
adjustment is not needed at the field. When replacing the
FM front end assembly, no adjustment is needed either.
2: The parts in the FM front end section are prepared in a
complete unit, so you can't obtain each part individually.
SW EXTRA FUNCTION
To Next Page
Loading...
