Sharp HT-CN650DVW - Sleep Operation

50
HTCN650DVW_AUS.fm03/10/29
HT-CN650DVW
Advanced Features
- Sleep operation -
Sleep operation
 Setting the sleep timer
You can set the unit to the power stand-by mode at the specified time.
To cancel the sleep operation:
To cancel the sleep operation, press the SLEEP button until “OFF” appears on the
display.
To confirm the remaining sleep time:
Press the SLEEP button whilst the sleep timer is set.
The remaining sleep time is displayed for about 5 seconds.
Caution:
This unit cannot set the sleep timer of other equipment.
To use the sleep timer using other equipment, you should also set the timer on
the equipment separately.
ON STAND-BY OPEN CLOSE
PRESET MUTE PRESET
OSDPLAYSLOW
TUNING TUNINGSTOP
P
AUSE
TITLE
SETUP
ENTER
FUNCTION
MENU
PBC
RETURN
LISTENING
EQUALIZER PROG
MODE
MIC
ECHO
VOLUME
ANGLEZOOMSUBTITLEAUDIO
SLEEP DIRECT REPEAT A-B
123
456
78
0
9
ON STAND-BY
SLEEP
1 Playback the desired sound source.
2 Press the SLEEP button.
TV screen Unit display
To change the sleep time:
Press the SLEEP button repeatedly to select the desired sleep time. The time will
decrease as follows.
3 Your system will enter the power stand-by mode automatically
after the preset time has elapsed.
Sleep 120mins
SLEEP
OFF120 MINS
30 MINS60 MINS90 MINS