Sharp HT-DV30H - DVD Firmware Update Test Mode

HT-DV30H
2 – 4
[4] DVD Firmware Update Test Mode
After enter testmode menu, press
[PLAY] key at main unit to select
"FW UPDATE TEST MODE" to
enter this mode
After ENTER key is pressed,
unit display at lower row will show
"_UPDATING_" blinking display
Press ENTER
key to start F/W upgrade.
After update process completed,
new firmware version will be
displayed in unit display lower row as
"FW_SRCV_ϠϠ"
END
Plug in USB device
User press [ON/STAND-BY]
key to exit this testmode
When enter firmware upgrade menu,
unit display at lower row change to
"FW_SRCV_ϠϠ" blinking at 2Hz
Note 2:
Make sure there is "DVDROM.bin" file inside the usb device
Note 3:
"_UPDATING_" blinking display means DVD
firmware upgrade is in progress.
During firmware upgrading is in progress, do not
POWER OFF the unit!
Note 1:
To enter testmode, during AC supply off
condition, whilst pressing down STOP key and
ON/STAND-BY key together, turn ON AC Supply.
" FW_UPDATE_ " will appear on upper row of
unit display and current firmware version DVD
will appear on lower row of unit display as "
FW_SRCV ** "