E-21
ENGLISH
ERROR DISPLAY
If the error continues to occur, contact a Sharp Service Centre.
DIGITAL
INDICA-
TION
ERROR DETAILS REMEDY
Humidity filter error. Make sure that the Humidifying Filter,
Humidifying Tray, and Water Tank are
properly installed, and then turn the power
to ON again.
Fan motor error.
Turn the power OFF to cancel the error
display, wait one minute, and then turn the
power ON.
Temperature-humidity sensor error. Unplug the unit, wait one minute, then plug
the unit in again.
Circuit board error.
Plasmacluster Ion Generating Unit error. Make sure that the Plasmacluster Ion
Generating Unit is correctly installed.
Remove the unit, and then fully reinsert it
and press the Operation Button. (Ref. E-17)
Low Plasmacluster Ion level.
Clean the electrode section of the unit and
Front Pre-filter.
OM_KI-A60Y_EN+ID.indb Sec1:21 2/28/12 11:16:30 AM
To Next Page
Loading...
