Sharp KI-L60TA - Humidifying Filter and Tray Maintenance

EN-13
ENGLISH
1. Remove the
Humidifying
Filter and Tray.
2. Rinse with plenty of water.
3. Attach the Humidifying
Filter and Tray.
HUMIDIFYING FILTER / HUMIDIFYING TRAY
NOTE
How to clean hard to remove dirt.
NOTE How to install the Float and the Rollers
Float
Tray Panel
Roller
• Do not remove the Float and the
Rollers. If they come o󰀨, refer to
below.
Kitchen detergent
(only Humidifying tray)
Citric acid
(available at some drugstores)
100% bottled lemon juice
with no pulp
1
1. Fill the tray half-way with
water.
2. Add a small amount of
kitchen detergent.
2 1/2 cups of water
3 teaspoons
3 cups of water
1/4 cup
2
Soak for 30
minutes.
Soak for 30 minutes.
(When using lemon juice as your
descaling solution, allow for more
soak time.)
3
Rinse off the kitchen detergent or the descaling solution with clean water.
RollerFloat
1. Insert the Float under
this tab.
3. Insert the tab on the other
side of the float into the
hole.
Tab
Float
Cross-Section view
2. Insert the tab of the float
into the hole.
Click
Click
• After maintenance, correctly
reattach the parts.
KI-L60TA_EN.indd 13 2020/08/28 15:47:55