EN-14
Remove the dust on the filters.
HEPA Filter
Tag
Deodorizing Filter
CAUTION
Do not wash the filters. Do not expose to sunlight.
(Otherwise these filters may lose efficacy.)
Connection Terminals
1. Remove the Unit Cover, and pull out
the Unit Holder.
2. Remove dusts from the Electrode
Section.
3. Insert the Unit Holder in the product,
and install the Unit Cover.
Unit Cleaning
Brush
Unit Cleaning Brush
Electrode
After cleaning
Before
cleaning
Around the base
Electrode
Click
HEPA FILTER /
DEODORIZING FILTER
PLASMACLUSTER ION
GENERATING UNIT
(Electrode Section)
CAUTION
• Do not clean with anything other than the Unit
Cleaning Brush. Doing so could lead to failures in
the Unit.
• A bent electrode could be cut o and dropped
during the cleaning process, but it will not change
the performance.
• Do not touch the electrode directly. Doing so could
lead to pain / itching.
• Do not transform the Electrode Section. Doing so
can damage it.
• Do not touch the Connection Terminals. Doing so
can damage them.
1. Remove the Side Panel.
2. Remove the Sensor Filter.
3. If the Sensor Filter is very dirty, wash it with water
and dry it thoroughly.
SENSORS
How to clean hard to remove dirt.
Remove the
dust gently
with a cleaning
tool such as a
vacuum cleaner.
Sensors
Sensor Filter
NOTE
Clean only the tagged
surface. Do not clean
up the opposite
surface. The filter is
fragile, so be careful
not to give too much
pressure.
Both surfaces can
be cleaned. The filter
may be broken if being
too much pressure is
applied on it, so please
handle it with care.
Some odors absorbed by the filters will break down
over time, causing additional odors. Depending
on usage conditions, and especially if the product
is used in environments significantly more severe
than a normal household, these odors may become
noticeable sooner than expected.
Replace the filter in those cases or if dust is unable
to be removed after maintenance.
NOTE
KI-L60TA_EN.indd 14 2020/08/28 15:47:56
To Next Page
Loading...
