EN-19
ENGLISH
FILTER MAINTENANCE
LAMP
When the cumulative operation period or the water
containing period is more than approximately 720
hours, the Filter Maintenance Lamp will turn on.
• It will not calculate the time when the product is
unplugged.
• 30 days × 24 hours = 720 hours
This is a reminder to perform the maintenance for
the Humidifying Filter and Tray, Main Body, Back
Panel, and Sensors.
After maintenance, connect the power plug to the
wall outlet and press Power ON/OFF Button, then
press and hold the Filter Reset Button for 3 seconds
to reset the Filter Maintenance Lamp.
Press for 3 sec.
♪
NOTE
How to Clean Hard-to-Remove Dirt.
Back Panel
1. Add a small amount of
mild kitchen detergent to
water and soak for about
10 minutes.
2. Rinse off the mild kitchen
detergent with clean
water.
3. Completely dry the filter
in a well-ventilated area.
Back Panel
Sensor Filter
1. Remove the Back Panel.
2. Remove the Sensor
Filter.
3. If the Sensor Filter is very
dirty, wash it with water
and dry it thoroughly.
Sensor Filter
MAIN BODY / BACK
PANEL / SENSORS
Wipe with a dry, soft
cloth.
Remove the dust gently with a cleaning
tool such as a vacuum cleaner.
Back Panel (Pre-Filter)
Sensors
Sensors
NOTE
•
Do not apply excessive pressure when
scrubbing the Back Panel.
WATER TANK
Rinse the inside with
water.
NOTE
How to Clean Hard-to-Remove
Dirt.
Clean the inside of the Water Tank with a soft
sponge and the Tank Cap with a cotton swab or
toothbrush.
Tank Cap Toothbrush
To Next Page
Loading...
