11
Basic Operation (Continued)
Changing Channels
You can select channels using Channel Select or
P ( )/( ) (Channel).
• To handle the increasing number of channels available, this LCD
TV set allows you to select up to 200 channels (0 to 199).
■ Using Channel Select
When selecting the channel using Channel Select, finish
inputting the channel number by holding down the button for
the last digit for a moment.
To select a one-digit channel (e.g. Channel 5)
● Hold down the
button.
To select a two/three-digit channel (e.g. Channel 15)
Press the
button.
Hold down the
button.
■ Using P ( )/( ) (Channel)
● Press P ( ) to change the channels in the following order:
1 → 2 → 3 → . . . → 198 → 199 → 0 → 1 → 2 → 3 → . . .
● Press P ( ) to change the channels in the following order:
3 → 2 → 1 → 0 → 199 → 198 → . . . → 3 → 2 → 1 → . . .
• Channel “0” is reserved for RF output of VCR.
• Channels not set with “Automatic search” or via “Setup” are set to
be skipped and therefore cannot be displayed using P ( )/( )
(Channel).
■ Using
AA
AA
A (Flashback)
● Press
AA
AA
A to switch the currently tuned channel to the
previously tuned channel.
● Press
AA
AA
A again to switch back to the currently tuned
channel.
Sound Volume
To adjust the volume
● Press i (+) to increase the sound volume.
• The bar indicator shifts right.
● Press i (–) to decrease the sound volume.
• The bar indicator shifts left.
To mute the sound
● Press
ee
ee
e (Mute) to temporarily turn off the sound.
• “Sound off” is displayed.
● Press
ee
ee
e (Mute) again to turn off the Mute function.
• “Sound on” is displayed.
• When i (+)/(–) is pressed in the Mute mode, the sound turns
on, and the volume indicator is displayed.
• The Mute function is cancelled when
BB
BB
B is pressed.
2
1
LC-13_15_20SH1E_E_P10-14.p65 2004.12.20, 6:29 PM11
To Next Page
Loading...
Need help?
General