Appendix
Removing the stand
Before detaching (or attaching) stand, unplug the AC cord from the AC INPUT terminal.
CAUTION
Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Before attaching/detaching stand
Before performing work make sure to turn off the TV.
Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
NOTE
To attach the stand, perform the above steps in reverse order.
Setting the TV on the wall
CAUTION
Installing the TV requires special skill that should only be performed by qualified service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting
that results in accident or injury.
Using an optional bracket to mount the TV
You can ask a qualified service professional about using an optional bracket to mount the TV to the wall.
Carefully read the instructions that come with the bracket before beginning work.
Vertical mounting Angular mounting
Hanging on the wall
Wall mount bracket. (See the bracket instructions for details.)
2
Unfasten the four screws used to
secure the stand in place.
1
Unfasten the screw used to secure the
bracket in place.
3
Detach the stand from the TV.
(Hold the stand so it will not drop from
the edge of the base area.)
About setting the TV angle
5
o
No power
Unit cannot be operated.
Remote control unit does not
operate.
Picture is cut off/with sidebar
screen.
Strange color, light color, or color
misalignment
Power is suddenly turned off.
No picture
No sound
Problem Possible Solution
Check if you pressed TV POWER on the remote control unit.
If the indicator on the TV does not light up, press TV POWER on the remote
control unit.
Is the AC cord disconnected?
Has the power been turned on?
External influences such as lightning, static electricity, may cause improper
operation. In this case, operate the unit after first turning on the power of the TV
or unplugging the AC cord and replugging it in after 1 or 2 minutes.
Is the FUNCTION set correctly? Set it to the TV setting position.
Are batteries inserted with polarity ( , ) aligned?
Are batteries worn out? (Replace with new batteries.)
Are you using it under strong or fluorescent lighting?
Is a fluorescent light illuminated near the remote control sensor?
Is the image position correct?
Are screen mode adjustments such as picture size made correctly?
Adjust the picture tone.
Is the room too bright? The picture may look dark in a room that is too bright.
Is the sleep timer set?
Check the power control settings.
The unit's internal temperature has increased.
Remove any objects blocking vent or clean.
Is connection to other components correct?
Is correct input signal source selected after connection?
Is the correct input selected?
Is picture adjustment correct?
Is "On" selected in "Audio Only"?
Is the volume too low?
Is "Variable" selected in "Output Select"?
Troubleshooting
Cautions regarding use in high and low temperature environments
When the unit is used in a low temperature space (e.g. room, office), the picture may leave trails or appear slightly
delayed. This is not a malfunction, and the unit will recover when the temperature returns to normal.
Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight or near
a heater, as this may cause the cabinet to deform and the Liquid Crystal panel to malfunction.
Storage temperature:
–
4
o
F to +140
o
F (
–
20
o
C to +60
o
C)
Troubleshooting-Digital broadcasting
The error message about reception of broadcast
The example of an error message
displayed on a screen
Error code Possible Solution
Failed to receive broadcast.
E202
No broadcast now.
E203
Check the antenna cable. Check that the antenna is correctly
setup.
Check the broadcast time in the pr
ogram guide.
+
_
To Next Page
Loading...
Need help?
General