24
Display
AVC System
Turning on/off the power
Make sure that the system cable is connected before
turning on the power.
POWER indicatorPOWER
POWER
Display/AVC System status indicator
POWER indicator
1
2
Plug in the AC cords of both the Display and the
AVC system. (See page 23.)
• The system enters standby mode or turns on depending on
its status at the time the power was shut down.
When the system is standby mode: Press POWER
on the Display or the AVC system, or TV POWER on
the remote control to turn on the power.
• To go to standby mode when the system is on, press POWER
on the Display or the AVC system, or TV POWER on the remote
control.
• To turn off the power completely, remove the AC cords from
the power outlet when the system is in standby mode.
NOTE
• The initial setup starts when the System powers on for the first time. If the
System has been turned on before, the EZ setup will not be invoked. See
page 31 to try EZ setup from the Setup menu.
• If you are not going to use this System for a long period of time, be sure
to remove the AC cords from the power outlet.
Watching TV
NOTE
• Check if the system cable is connected properly when display indicator flashes red.
ON
w/o CableCARD
When CableCARD
inserted
Standby
OFF (Standby)
CableCARD is downloading data.
Lighting (Blue)
Lights off
Lighting (Blue)
Lights off
Lighting (Red)—
TV POWER
CAUTION
• Please do not unplug the AC cord when the POWER indicator
is red.
LC-45GX6U(E)-020-029 04.7.8, 8:43 AM24
To Next Page
Loading...
Need help?
General
