Sharp LC-46DH65E - Page 33

LC-46DH65E/S, LC-46DH66E
3 – 15
5. If any of the procedures fails, the following upgrade failure screen shows up. For the failing procedure, the “NG” marking turns red.
NOTE: In such case, try to upgrade the software again. If it still fails, the hardware may be in trouble.
6. When all the procedures are complete, the following upgrade success screen shows up. The new software version can be confirmed on screen.
The version number appears when each item has been successfully upgraded. Finally the main version number appears on screen.
7. Turn off the AC power (Unplug the AC power cord). Take out the upgrading USB flash memory.
It waits for about 20 seconds until the AC power supply is turned off.
8. Now the software has been upgraded.
<SYSTEM UPG RADE>
System V ersion: E0708021
BANK1
BANK2
BANK3
STATUS
UPDATING .. .
30%
0%
0%
<SYSTEM UPG RADE>
System V ersion: E0708021
BANK1
OK
BANK2
OK
BANK3
STATUS
UPDATING .. .
100%
100%
44%
<SYSTEM UPG RADE>
System V ersion: E0708021
BANK1
OK
BANK2
OK
BANK3
STATUS OK
UPGRADECOMPLETE
100%
100%
100%