EN 24
Teletext 2.5
Teletext 2.5 offers more colours and better
graphics than normal teletext. If Teletext 2.5
is broadcast by a channel, it is switched on
by default.
To switch Teletext 2.5 on or off
1. Press MENU.
2. Select [Setup] > [TV settings] >
[Preferences].
3. Select [Text 2.5] > [On] or [Off], then
press OK.
Set locks and timers
Clock
You can display a clock on the TV screen.
The clock displays the time that is broadcast
by your TV service operator.
Display the TV clock
1. While you watch TV, press OPTIONS.
2. Select [Status], then press OK.
The clock is displayed on the lower right
hand corner of the TV screen.
Change the clock mode
The clock mode is automatically
synchronised to the Coordinated Universal
Time (UTC). If your TV cannot receive UTC
transmissions, change the clock mode to
[Manual].
1. While you watch TV, press MENU.
2. Select [Setup] > [TV settings] >
[Preferences].
3. Select [Clock] > [Auto clock mode].
4. Select [Automatic], [Manual] or [Country
dependent], then press OK.
Enable or disable daylight saving
If clock mode is set to [Country
dependent], you can enable or disable
daylight saving for your time zone.
1. In the [Clock] menu, select [Daylight
saving] > [Daylight saving time] or
[Standard time], then press OK. Daylight
saving is enabled or disabled.
Set the clock manually
If clock mode is set to [Manual], set the date
and time manually.
1. In the [Clock] menu, select [Date] or
[Time], then press OK.
2. Use the Navigation buttons to make your
selection.
3. Select [Done], then press OK.
Sleeptimer
Sleeptimer switches the TV to standby after
a specified time. You can switch off your TV
earlier or reset the sleeptimer during the
countdown.
1. Press MENU.
2. Select [Setup] > [TV settings] >
[Preferences] > [Sleeptimer].
3. Press the Navigation buttons to set the
sleeptimer.
The sleeptimer can be set up to 180
minutes, in steps of five minutes. The
sleeptimer is switched off if it is set to zero
minutes.
4. Press OK to activate the sleep timer. The
TV switches to standby after the specified
time.
Child lock
To protect children from unsuitable TV
programmes, you can lock the TV or block
age rated programmes.
Set or change the child lock code
1. Press MENU.
2. Select [Setup] > [Channel settings] >
[Child lock].
3. Select [Set code], or [Change code].
4. Enter the code with the Numeric
buttons.
Tip: If you forget your code, enter '8888' to
override any existing codes.
Lock or unlock channels
1. In the child lock menu, select [Channel
lock].
2. Enter the child lock code with the
Numeric buttons. The [Channel lock] menu
appears.
3. Select channels to lock or unlock.
To Next Page
Loading...
Need help?
General