Sharp MD-MS722H

■ To eliminate the confirmation
sound
Every time a button is pressed, a “beep”
will be heard in the earphones.
To silence the “beep” sound, do the follow-
ing:
1 Whilst in the stop mode ...
Hold down the MODE button on the
main unit or move the shuttle switch on
the lower right of the remote control unit
down until "SET UP" appears.
● When you release the button, “BEEP
1 (BEEP ON)” will appear.
2 Press the MODE button on the main
unit or move the shuttle switch on the
lower right of the remote control unit
down.
● “BEEP 0 (BEEP OFF)” will appear,
and the confirmation sound will dis-
appear.
● To restore the confirmation sound,
select “BEEP 1 (BEEP ON)”.
3 Press the ■/:OFF button.
● The normal display will reappear.
■ To turn off the display
backlight
Whenever you press a button, the display
will light for about 7 seconds, so that you
can read it in the dark. You can turn off the
backlight.
1 Whilst in the stop mode ...
Hold down the MODE button on the
main unit or move the shuttle switch on
the lower right of the remote control unit
down until "SET UP" appears.
● When you release the button, “BEEP
1 (BEEP ON)” or “BEEP 0 (BEEP
OFF)” will appear.
2 Turn the jog dial until "EL on 1 (EL ON
1)" appears.
3 Press the MODE button on the main
unit or move the shuttle switch on the
lower right of the remote control unit
down.
● Whenever the button is pressed
EL ON 1 (EL on 1) → EL ON 2 (EL on 2)
EL OFF (EL off)
"EL OFF (EL off)" will go out.
To turn the backlight on:
"EL ON 1 (EL on 1)"
When any button is pressed, the backlight
will remain lit for about 7 seconds.
"EL ON 2 (EL on 2)"
When the rechargeable battery or alkaline
battery is used, the backlight will remain lit
for about 7 seconds.
When the AC adaptor or a car adaptor is
used and the power is turned on, the back-
light will always be lit.
(However, the brightness may be a little
less than when using the battery.)
4 Press the ■/:OFF button.
● The normal display will reappear.
:OFF
MODE
PLAY
MODE
: OFF
Jog dial
36
MD-MS722H(SUK)