Sharp MD-MT866H - Basic Operation: Playback Introduction; Preparing for Playback

MD-MT866H/MD-MT866W
– 24 –
S F
f i
E F
DISP
DISP
S E e i
E F
DISP
DISP
DISP
DISP
• LPFFINO/EFMIO measurement value
• LPFEINO/EFMIO measurement value
G C H
e f
DISP DISP
P C H
S B
a b
DISP DISP
S A
• LPFEFO measurement value
• LPFABO measurement value
S b A B
DISP DISP
S a
• ABMAXO measurement value
* In the specific setting display state the setting change digit changes when the [P-MODE] button is pressed. • In the case of the setupvalue two digits.
1st digit (initial value) 2nd digit
• In the case of the setupvalue three digits.
1st digit (initial value) 2nd digit 3nd digit
* In the specific state the setting changes in the range of "0h to Fh" when the [VOL UP/DOWN] button is pressed. * If the [DISP] button is pressed, the display changes as follows.
P-MODE
P-MODE
P-MODE
* If the [BASS] button is pressed in the laser ON state (with no disc or the lid open), laser power changes as follows.
1 (initial value) 10 384
BASS
BASS
BASS
* In the start address set state the value of selection digit changes in the range of "0h to Fh" when the [SKIP UP/DOWN] button is pressed
L O N P
L O N R
L O N M
: EFMIO measurement value indication "REPEAT", "1" Mark lighting
: LPFFINO measurement value indication "1" Mark lighting
: F-ATT (tracking) initial setting
: EFMIO measurement value indication "REPEAT", "1" Mark lighting
: LPFEINO measurement value indication "1" Mark lighting
: E-ATT (tracking) initial setting
: LPFEFO measurement value indication "1" Mark lighting
: Pit section adjustment COUT level setting : Group section adjustment COUT level setting : LPFABO measurement value indication "1" Mark lighting
: ABMAXO measurement value indication "1" Mark lighting
: A-ATT (focus) tentative setting : B-ATT (focus) tentative setting
: A-ATT (focus) tentative setting : B-ATT (focus) tentative setting
Play back Record paper Maximun power
P-MODE
: Pre-Manual Adjustment menu
: Temperature code indication
$ $ : Temperature code
: A signal offset (AINO) measurement
: Measurement value
: B signal offset (BINO) measurement
: Measurement value
: E signal offset (EINO) measurement
: Measurement value
: F signal offset (FINO) measurement
: Measurement value
: Laser ON (play power)
: AB signal level measurement (ABMAXO)
: Measurement value
: A-ATT (focus) tentative setting
: ATT setting
: B-ATT (focus) tentative setting
: ATT setting
: Pit section adjustment COUT level setting
: COUT level setting
: Groove section adjustment COUT level setting
: COUT level setting
: E-ATT (tracking) initial setting
: ATT setting
: F-ATT (tracking) initial setting
: ATT setting
PLAY
M A N U 1
Servo Pre-Manual Adjustment
T M P $ $
A h
SKIP UP SKIP DOWN
B h
SKIP UP SKIP DOWN
E h
SKIP UP SKIP DOWN
F h
SKIP UP SKIP DOWN
L O N P
SKIP UP SKIP DOWN
A B
SKIP UP SKIP DOWN
S a
SKIP UP SKIP DOWN
S b
SKIP UP SKIP DOWN
e f
SKIP UP SKIP DOWN
P C H
SKIP UP SKIP DOWN
e f
SKIP UP SKIP DOWN
G C H
SKIP UP SKIP DOWN
T C
SKIP UP SKIP DOWN
S E
SKIP UP SKIP DOWN
S F
SKIP UP SKIP DOWN SKIP UP SKIP DOWN
: Pit section EF signal level measurement (LPFEFO)
: Measurement value
: Groove section EF signal level measurement (LPFEFO)
: Measurement value
: TCRS signal level measurement (TCRSMIO)
: Measurement value
: A-ATT (focus) initial setting
: ATT setting
: B-ATT (focus) initial setting
: ATT setting
: TCRS signal offset (TCRSO) measurement
: Measurement value
a b S A
SKIP UP SKIP DOWN
S B
SKIP UP SKIP DOWN
T H
SKIP UP SKIP DOWN
: AB input level measurement (LPFABO)
: Measurement value