Sharp MX-4500N - Page 357

MX3500N MANUAL PAPER FEED SECTION D – 5
c. Separation roller
1) Remove the MF pickup cover.
2) Remove the paper pickup roller and the paper feed roller.
3) Open the MF lower maintenance cover, remove the separation
roller.
d. Manual paper feed gate solenoid
1) Remove the manual paper feed unit.
2) Remove the MF base guide supporting plate and the spring.
3) Disconnect the connector, and disengage the pawl. Remove
the manual paper feed gate solenoid.
e. Transport roller 12 (Drive)
1) Remove the manual paper feed unit.
2) Remove the MF base guide supporting plate and the spring.
3) Remove the parts, and remove the transport roller 12 (Drive).
f. Manual feed paper entry detection
1) Remove the manual paper feed unit.
2) Remove the MF base guide supporting plate and the spring.
3) Remove the transport roller 12 (Drive).
4) Disconnect the connector, and remove the MF front plate.
Remove the transport roller 7 (Idle) unit.
5) Disconnect the connector, and remove the sensor mounting
plate.
1
2
1
1
2
2
1