1-81
BEFORE USING THE MACHINEâ–ºLOADING PAPER
LOADING PAPER INTO THE BYPASS TRAY
Use the bypass tray for printing on plain paper, label sheets, tab paper, and other special media.
A maximum of 100 sheets of paper can be loaded into the bypass tray (on the machine), or a maximum of 500 sheets can
be loaded in the bypass tray (on the large capacity trays), and continuous printing is possible as is the case with other trays.
For detailed information on the sizes and types of paper that can be loaded into the bypass tray, see
"SPECIFICATIONS" in the "Start Guide" and "Paper Tray Settings (page 7-103)
".
How to place the original
Load paper up to 7-1/4" × 10-1/2" (A5) size in landscape orientation.
• When using plain paper other than Sharp standard paper or special media other than SHARP-recommended transparency
film, or when printing on the reverse side of paper that has been printed on one side, load paper one sheet at a time.
Loading more than one sheet at a time will cause misfeeds.
• Before loading paper, straighten any curling in the paper.
• When adding paper, remove any paper remaining in the bypass tray, combine it with the paper to be added, and reload as
a single stack. If paper is added without removing the remaining paper, a misfeed may result.
Bypass tray (on the machine) Bypass tray (on the large capacity trays)
To Next Page
Loading...
Need help?
General
