Sharp MX-B201D

TEST SIMULATION
SHARP
28
24
Data Counter & Clear
8
Copy counter clear
9
Printer counter clear
10
Fax counter clear
13
Scanner counter clear
14
RSPF jam counter clear
15
Scanner mode counter clear
25
Toner Monitor & Polygon Check
1
Main motor operation check (Process)
10
Polygon motor operation check
26
Device Configuration
2
RSPF setting
3
Second cassette setting
4
Main unit duplex setting
6
Destination setting
7
Machine conditions check
20
Rear edge void setting
30
CE mark support control
37
Cancel of stop at developer life over
39
Memory capacity check
40
Polygon motor off time setting
42
Transfer ON timing control setting
43
Side void amount setting
54
Life correction setting
62
Energy-save mode copy lamp setting
69
Toner near end condition setting
30
Sensor Operation & Test
1
Main unit sensor check
41
OC Cover Operation & Adjustment
6
OC Float detection level adjustment
7
OC detection margin setting
43
Fuser Setting & Adjustment
1
Fusing temperature setting (Normal copy)
4
Fusing temperature setting in multi-copy
5
Fusing temperature setting in duplex copy
14
Fusing start temperature setting
46
Copy & Image Density Adjustment
1
Copy density adjustment (300 dpi)
2
Copy density adjustment (600 dpi)
12
Copy density adjustment in FAX mode
13
FAX mode density adjustment (normal)
46
Copy & Image Density Adjustment
14
FAX mode density adjustment (fine)
15
FAX mode density adjustment (super fine)
18
Image contrast adjustment (300 dpi)
19
Exposure mode setting (AE mode)
20
RSPF exposure correction
29
Image contrast adjustment (600 dpi)
30
AE limit adjustment
31
Image sharpness adjustment
32
Copier colour reproduction setting
39
FAX mode sharpness adjustment
48
Magnification & Motor Adjustment
1
Main scan magnification ratio adjustment
5
SPF Sub scan magnification ratio adjust
49
Firmware Upgrade
1
Flash ROM program writing mode
2
ANB Download mode (MXNB11)
50
Image Position Adjustment
1
Image lead edge adjustment
6
Copy lead edge position adjustment (SPF)
10
Paper off-centre adjustment
12
Document off-centre adjustment
18
Reverse position adjustment (duplex
copy)
19
Duplex copy rear edge void adjustment
27
OC rear edge position adjustment
51
Resist Roller Adjustment
2
Resist roller adjustment
53
Document Feeder Adjustment
8
RSPF document scan start position.
61
LSU Writing Adjustment/Test
1
LSU test (Polygon motor & BD signal)
63
CCD Operation & Adjustment
1
Shading correction data display
2
Black level automatic correction
12
Light quantity stabilization wait time
setting
13
Light quantity stabilization band setting