User Program Entry
1. Press the [MENU] key and then press the [ENTER] key.
For Printer mode, press the [MENU] key only.
2. Press the [<] key [v] or [>] key [^] to select the item that you wish to configure in the USER
PROGRAM, then press the [ENTER] key.
You can also select a program by directly entering the program number with the numeric key.
3. Press the [<] key [v] or [>] key [^] to change the setting of the selected item.
Note:
If you select the wrong item, press the [CLEAR] key [C] and repeat the procedure from Step2.
To cancel a setting for a user program, press the [MENU] key.
4. Press the [ENTER] key. Your selection appears briefly and then the previous screen appears.
Note:
When "AE LEVEL ADJUST" is selected in the user programs and the [ENTER] key is pressed,
the automatic exposure adjustment screen appears. Adjust the exposure and press the
[ENTER] key.
To Next Page
Loading...
