1-72
BEFORE USING THE MACHINE
Contents
8
Clean the laser unit.
(1) Point the cleaner down and slowly insert
the tool into the hole that you wish to clean.
The parts of the writing unit that require cleaning are
indicated by labels similar to (A).
(2) Insert the cleaning tool all the way into the
hole and then pull it back out.
Pull the cleaning tool out until you feel the tip of the tool
leave the cleaning surface of the laser unit.
(3) Repeat step (2) two or three times and then
remove the cleaning tool.
9
Replace the cleaning tool.
(1) Rotate the cleaning instrument after putting
it on the boss and hook its edge (the side
where the cleaner is fixed) to the claw on
the left side.
(2) Place the right-hand side of the cleaning
instrument on the front side, spread across
the top of the claw.
(3) Hook the cleaning instrument to the claw.
10
Install the toner collection container.
☞
REPLACING THE TONER COLLECTION
CONTAINER (page 1-55)
(A)
(1)
Boss
(2)
(3)
(1)
(2)
To Next Page
Loading...
