Sharp MX-B382 - Frequently Asked Questions; Making a Copy of a Non-Standard Size Original

8-4
TROUBLESHOOTING
Contents
MAKING A COPY OF A NON-STANDARD SIZE
ORIGINAL
The procedure for making a copy of a payment slip or other non-standard size
original is explained below.
The "Centring" special mode of copy mode can be selected to position the copied
image in the centre of the paper.
FREQUENTLY ASKED QUESTIONS
200
X
Y
150
Original
Size Input
OK
OKCancel
(25 356)
mm
(25 216)
mm
1 Place the originals. 2 Enter the original size.
From the base screen of copy mode,
touch [Original] then [Size Input].
If the dimensions of the document are less than
the following dimensions, place the original on
the document glass.
When using the MX-B382:
X dimension (width): 89 mm (3-1/2")
Y dimension (height): 100 mm (4")
When using the MX-B382SC:
X dimension (width): 85 mm (3-1/4")
Y dimension (height): 51 mm (2")
When using the automatic document feeder, use
"Slow Scan Mode" for a thin original.