Sharp MX-B382 - Page 535

5-58
SCANNER/INTERNET FAX
Contents
3
MX-B382:
Specify the scan size.
(1) Touch the appropriate original size key.
(2) Touch the [OK] key.
MX-B382SC:
Specify the scan size.
(1) Touch the original output destination.
(2) Touch the appropriate original size key.
(3) Touch the [OK] key.
• If you are sending a long original, touch the [Long Size] key. Use the automatic document feeder to scan a long
original. The maximum width that can be scanned is 500 mm (19-5/8") (the maximum height is 216 mm (8-1/2")).
•
To specify an Inch size for the scan size, touch the [AB Inch] key to highlight the [Inch] side and then specify the scan
size.
MX-B382-SC Only
•
In the situations below, the original exit place is fixed to the heavy exit.
- When "Card Size" is selected
- When the original guide is set to 74 mm (2-7/8") or lower (Except when "Check Size" is selected)
- When the automatic document feeder is scanning an original with an X (horizontal) value of 105 mm (4-1/8") or
less
•
When "Card Size" is selected, you cannot scan originals if the original guide is set to 74 mm (2-7/8") or higher.
4
Touch the [OK] key.
When [Long Size] is selected, the 2-sided scanning setting and send size cannot be changed. In addition, when only scan
destinations are selected for scan transmission or metadata transmission, scanning will take place in Mono2.
216x330
A4
16K
216x340B5
Scan/Original
216x343
A5
Long Size
OK
AB
Inch
Size Input
(2)(1)
8½x13
5½x8½
Scan/Original
AB
Inch
OK
216x330
216x340
216x343
A4
A5
B5
Check Size
Card SizeSize Input
16K
Long Size
Heavy Exit
Upper ExitUpper Exit
Original Exit
Place
Original Size
(3)
(
2
)
(1)
Scan/Original
OK
Auto
B5
Scan Size
2-Sided
Tablet
2-Sided
Booklet
Send Size
100%
Image Orientation