1-38
BEFORE USING THE MACHINE
Contents
Useable card specification
Please use cards that conform to ISO 7810 ID-1/ID-2 types.
• Cards that are hard and difficult to bend may not feed well.
• If the card surface is soiled with oils (finger oil, etc.), wipe it off first before scanning.
Originals that cannot be fed through the automatic document feeder
Do not use the following originals. Original misfeeds, and smudges may result.
• Transparency film
• Tracing paper
• Carbon paper
• Thermal paper or originals printed with thermal transfer ink ribbon
• Originals to be fed through the feeder should not be damaged, crumpled, folded, loosely pasted together, or have
cut-out holes
• Originals with multiple punched holes other than two-hole or three-hole punched paper
• Originals that have been scanned multiple times in the automatic document feeder and have become creased or
folded.
• Originals that have absorbed moisture and become soft.
MX-B382SC Only
ID-1 ID-2
Size
54 mm (height) x 86 mm (width)
(2-1/8" (height) x 3-3/8" (width))
74 mm (height) x 105 mm (width)
(3" (height) x 4-1/4" (width))
Thickness
0.76 mm (1/32") ± 0.08 mm (1/64")
Material
Polyvinyl chloride (PVC) or polyvinyl acetate (PVA/PVAC)
To Next Page
Loading...
