30
TROUBLESHOOTING AND MAINTENANCE
Section C
Remove the misfed original from the exit area.
If the misfed original cannot be easily removed
from the exit area, open the moveable part of the
document feeder tray and remove the original.
2
Open and close the SPF to make the
misfeed location indicator stop
blinking.
You can also make the
misfeed indicator stop
blinking by opening and
closing the feeding roller
cover or the right side
cover.
3
Return the originals indicated by the
minus number in the display to the
document feeder tray and press the
[START] key ( ).
Copying will resume from the originals that still
remained when the misfeed occurred.
MISFEED IN THE BYPASS TRAY
1
Carefully remove the misfed paper
from the bypass tray.
2
Grasp the side cover handle and
gently open and close the side cover.
The message " Clear paper
path." will be cleared and
copying will be possible.
Depending on the location of the misfeed,
the displayed number of originals to be
returned to the document feeder tray may
not be correct.
Note
If the message does not clear, check again
to make sure that no pieces of paper
remain.
Note
To Next Page
Loading...
Need help?
General
