Sharp MX-M200D User Manual

33
TROUBLESHOOTING AND MAINTENANCE
2
Misfeed in C
1
Lower (1) in the illustration, open the
fusing unit paper guide, and remove
the misfed paper.
Be careful not to tear the misfed
paper during removal.
2
If the misfed paper cannot be removed
by the previous step, remove it from
the paper output area.
Be careful not to tear the misfed
paper during removal.
3
Close the side cover.
The message " Clear paper
path." will be cleared and
copying will be possible.
MISFEED IN TRAY 1
1
Pull out tray 1 and remove the misfed
paper.
Be careful not to tear the misfed
paper during removal.
2
Open and close the side cover.
The message " Clear paper
path." will be cleared and
copying will be possible.
3
Gently push tray 1 into the machine.
Push the tray in completely.
The fusing unit is hot. Do not touch
the fusing unit when removing
misfed paper. Doing so may cause a
burn or injury.
(1)
Warning
• When closing the side cover, hold the
handle.
• If the paper was torn, make sure that no
torn pieces remain in the machine.
• If the message does not clear, check
again to make sure that no pieces of
paper remain.
Note
Make sure that there is no misfed paper in the tray before pulling it out. (Page 31)
Note
• When closing the side cover, hold the
handle.
• If the message does not clear, check
again to make sure that no pieces of
paper remain.
Note

Sharp MX-M200D Specifications

General

Brand	Sharp
Model	MX-M200D
Category	All in One Printer
Language	English