Sharp MX-M266N

INITIAL SETUP
SHARP
8
COPY IMAGE QUALITY
Check Image Quality (Copy Mode):-
If NG, perform the following adjustments as required:-
Sim 46-02 Copy Density Adjust. (600dpi).
Sim 46-09 SPF Copy Density Adjust.
PRINT IMAGE QUALITY
Check Image Quality (Print Mode):-
Sim 64-05 PCL Density Test Page.
Sim 64-06 PS Density Test Page [MX-PK11].
PERIPHERAL / OPTION CONFIGURATION
FAX OPTION – MX-FX11
Sim 66-02 Fax SW Setting (Destination).
Sim 66-10 Fax Memory Clear (For Extended Memory).
Sim 66-39 Fax Destination Set.
FINISHER OPTION – MX-FN26
Sim 26-65 Finisher Alarm Mode:-
Limit number of Copies in staple mode (ON/OFF).
USB WIRELESS ADAPTOR – MX-EB13
Sim 26-50 Activate Wireless Set, E: 0 = Disable, 1 = Enable.
EXTERNAL ACCOUNTING MODULE – MX-AMX3
Sim 55-03 Auto clear function before Copy job execution:-
SSW 1-5 0 = Disable, 1 = Enable.
Sim 55-03 Continuous print mode (job queuing for OSA):-
SSW 24-7 0 = Disable, 1 = Enable.
MFP DATA BACKUP
Sim 22-06 Data Simulation Print.
Device Clone & Storage Backup.
Sim 56-01 Backup EEPROM Data to HDD.