Sharp MX-M266N

7-35
SYSTEM SETTINGS
Contents
*1 When the hard disk drive is installed.
*2 When a paper tray is installed.
*3 When a finisher is installed.
Copy Function Settings
l Disabling of Devices 7-71
 Disabling of Document Feeder Disabled 7-71
 Disabling of Duplex Disabled 7-71
 Disabling of Optional Paper Drawer*
2
Disabled 7-71
 Disabling of Tray Settings Disabled 7-71
 Disabling of Finisher*
3
Disabled 7-71
 Disabling of Offset Disabled 7-71
 Disabling of Stapler*
3
Disabled 7-71
l Fusing Control Settings 16 - 23 lbs. (60 - 89 g /m
2
) 7-71
Item Factory default setting Page
n Copy Function Settings
7-72
l Initial Status Settings
7-72
 Color Mode Full Color
 Paper Tray Varies depending on the machine
configuration
 Exposure Type Auto
 Copy Ratio 100%
 2-Sided Copy 1-Side to 1-Side
 Output –
l Other Settings 7-73
 Copy Exposure Adjustment 7-73
 Rotation Copy Setting Enabled 7-73
 Add or Change Extra Preset Ratios – 7-73
 Setting a Maximum Number of Copies 999 7-73
 Initial Margin Shift Setting
7-73  Side 1 1/2"
 Side 2 1/2"
 Erase Width Adjustment
7-73  Edge Clearance Width 1/2"
 Center Clearance Width 1/2"
 Card Shot Settings
7-73  Original Size X: 3-3/8", Y: 2-1/8"
 Fit to Page Disabled
 Initial Tab Copy Setting 1/2" 7-73
Item Factory default setting Page