Sharp MX-M550N

MX-M700N TRANSFER SECTION M – 5
f. Transfer cleaning roller
1) Remove the transfer unit. (See “(1) Transfer unit”)
2) Remove the transfer belt unit. (See “a. Transfer drive gear”)
3) Remove the E-ring to remove the transfer cleaning roller.
g. Transfer cleaning brush
1) Remove the transfer unit. (See “(1) Transfer unit”)
2) Remove the upper transfer roller unit.
(See “a. Transfer drive gear”)
3) Remove the transfer belt. (See “b. Transfer belt”)
4) Remove the cleaning brush.
4. Maintenance
✕: Check {: Clean ▲: Replace U: Adjust ✩: Lubricate : Shift position
(Clean, replace, or adjust according to necessity.)
* When cleaning the transfer belt, never use alcohol, solvent, and water.
55ppm (PM: 250K)
When
calling
250
K
500
K
750
K
1000
K
1250
K
1500
K
1750
K
2000
K
Remark/Refer to the
Parts Guide.
Block/Item No.
(Only the replacement
parts are described.)
62ppm/70ppm (PM: 300K)
300
K
600
K
900
K
1200
K
1500
K
1800
K
2100
K
2400
K
Unit name No. Part name
Transfer section 1 Transfer drum gear ✕ ▲▲▲▲▲▲▲▲(P/G No.: [45]-25)
2 Transfer belt { ▲▲▲▲▲▲▲▲(P/G No.: [45]-50)
3 Transfer roller ▲▲▲▲▲▲▲▲(P/G No.: [45]-47)
4 Transfer roller collar ✕▲✕▲✕▲✕▲(P/G No.: [45]-48)
5 Shaft (Conductive grease) ✕ ✕✕✕✕✕✕✕✕UKOG-0012QSZZ
6 Paper guide { {{{{{{{{
2
3
5
5
5
1
4
4
5