Replacing the staple cartridge (saddle stitch unit)
Before starting this procedure, remove all output from the output tray of the saddle stitch finisher. Do not replace
removed output in the output tray.
1
Open the front cover.
2
Grasp the handle on the saddle stitch
unit and pull it slowly out until it stops.
3
Pull the staple unit in the saddle stitch
unit out and then rotate it up.
4
Grasp the left and right side of each
empty staple cartridge and remove the
cartridges.
5
Load new staple cartridges.
Replace both staple cartridges. Remove the cover from each
staple cartridge and then install the cartridge.
To Next Page
Loading...
