What to do if original misfeeds in Sharp All in One Printer automatic document feeder?
If the original misfeeds in the automatic document feeder, ensure the stack of paper in the tray is not higher than the indicator line. When scanning a long original, set the scan size to [Long Size]. If the original is on thin paper, use the document glass or slow scan mode in the special modes.
What to do if transmission does not take place on my Sharp MX-M950 due to file size?
If your administrator has set a limit on the size of transmitted files, a file that exceeds the limit cannot be transmitted. Check with your administrator. Reduce the size of the file attachment by reducing the number of pages scanned or by scanning using a lower resolution setting. You can also ask your mail server administrator what the file size limit is for one e-mail transmission. If the destination folder is not configured as a shared folder, select "share" in the folder properties. If the folder was moved or otherwise changed, the "share" setting may have been canceled.
What to do if my Sharp MX-M950 transmitted fax prints out blank at the receiving side?
Ensure the original is placed correctly (face up or face down, as required by the sending method) and send the fax again.
Why does my Sharp MX-M950 All in One Printer not print after reception?
If a message appears on the display indicating that you need to add toner or paper, printing will not be possible. Restore printing capability by following the instructions provided in the message.
Why is the scanned image clipped on my Sharp All in One Printer?
The original scan size setting might be smaller than the actual original size. Set the scan size to the actual original size. If you have intentionally set a smaller size than the actual original size, note carefully the placement position of the selected scan size when placing the original.
Why Sharp All in One Printer does not automatically select the original size?
If the original size is not automatically selected or the wrong size is selected, straighten the original if it is curled or folded. Original sizes smaller than 5-1/2" x 8-1/2" (A5) cannot be detected, so enter the original size manually.
Why does Sharp All in One Printer leave smudges on printed output?
Smudges on printed output may occur if you are not using SHARP-recommended paper. Using unsupported paper can result in smudges. Also, if printing on pre-punched paper, the image may overlap the punch holes, causing smudges. If a message appears indicating the need for maintenance, contact your dealer or nearest SHARP Service Department as soon as possible.
How to fix lines in scanned images from Sharp All in One Printer?
If lines appear in the scanned image, clean the scanning areas of the document glass or automatic document feeder. Also, clean the surface of the bypass feed roller.
Why can't I specify a destination on my Sharp MX-M950?
Some functions may have been disabled in the system settings (administrator). Check with your administrator. When user authentication is enabled, the functions that you can use and page counts may be restricted in your user settings. Check with your administrator.
Why does auto selection of the color mode not take place correctly on my Sharp MX-M950 All in One Printer?
When the color mode is set to "Auto", the machine detects whether the original is black and white or color when the [START] key is pressed; however, automatic detection may not give the correct result. In this event, specify the color mode manually.
General| Brand | Sharp |
|---|---|
| Model | MX-M950 |
| Category | All in One Printer |
| Language | English |
To Next Page
