18
3
Set the number of copies (number of
sets) with the numeric keys.
• Up to 9999 copies (sets) can be set.
• A single copy can be made even if "0" appears for the number of copies.
If an incorrect number of copies is set...
Press the [CLEAR] key ( ) and then enter the correct number.
4
Press the [START] key ( ).
Normally copying will start.
Depending on the copy settings (2-sided copying, etc.), copying may not begin until all originals have been scanned. In this
case, go to the next step.
5
Remove the original and place the next original, and then press the [START] key
().
Repeat this step until all originals have been scanned.
For the second original and following originals, use the same [START] key ( ) as you did for the first original.
6
Touch the [Read-End] key.
To cancel scanning of the original and copying...
Press the [STOP] key ( ).
7
Plain
8½x11
Special Modes
2-Sided Copy
5.
Read-End
Place next original. Press [Start].
When finished, press [Read-End].
To Next Page
Loading...
