1
Introduction
Before using the projector, please read this operation manual carefully.
Introduction                                  
ENGLISH
There are two important reasons for prompt warranty registration of your new 
SHARP Projec tor, using the REGISTRATION CARD packed with the projector.
1. WARRANTY
This is to assure that you immediately receive the full benefit of the parts, 
service and labor warranty applicable to your purchase.
2. CONSUMER PRODUCT SAFETY ACT
To ensure that you will promptly receive any safety notification of inspection, 
modification, or recall that SHARP may be required to give under the 1972 
Consumer Product Safety Act, PLEASE READ CAREFULLY THE IMPORTANT 
“LIMITED WARRANTY” CLAUSE.                                                       
U.S.A. ONLY
The enclosed computer cable must be used with the device. The cable is 
provided to ensure that the device complies with FCC Class A verification.
 
U.S.A. ONLY
WARNING: 
FCC Regulations state  that any unauthorized  changes or modifications 
to  this  equipment  not  expressly  approved  by  the  manufacturer  could 
void the user's authority to operate this equip ment.           
 
U.S.A. ONLY
WARNING:
This is a Class A product. In a domestic environment this product may cause 
radio interference in which case the user may be required to take adequate 
measures.
The lightning flash with arrowhead sym-
bol, within an equilateral triangle, is in-
tended to alert the user to the presence 
of  uninsulated  “dangerous  voltage” 
within the product's enclosure that may 
be of sufficient magnitude to constitute 
a risk or electric shock to persons.
The exclamation point within a triangle 
is intended to alert the user to the pres-
ence of important operating and main-
tenance  (servicing)  instructions  in  the 
literature accompanying the product.
See bottom of projector.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER.
NO USER-SERVICEABLE PARTS EXCEPT LAMP UNIT.
REFER SERVICING TO QUALIFIED SERVICE  
PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT REMOVE SCREWS 
EXCEPT SPECIFIED USER 
SERVICE SCREW.
WARNING: 
To reduce the risk of fire or electric shock, do not 
expose this product to rain or mois ture.
WARNING: 
High brightness light source. Do not stare into the beam of light, or view 
directly. Be especially careful that children do not stare directly into the 
beam of light.