Sharp PG-LX3000 - Adjusting the Projected Image (SCR-ADJ Menu); Setting The Resize Mode; Adjusting The Image Position; Keystone Correction

47
Useful
Features
Adjusting the Projected Image (“SCR-ADJ” Menu)
Menu operation n Page 40
SEL./ADJ. ENTER END
Resize
Image Shift 0
0
Keystone
OSD Display
Closed Caption
Overscan
Background
Setup Guide
PRJ Mode
On
Front
Wall Color
Language
Off
English
On
Off
Logo
On
Normal
Pict. PRJ1 PRJ2SIG
SCR-ADJ
9
8
0
5
6
4
3
2
1
7
1
Setting the Resize Mode
Use this function to stretch the image
vertically or horizontally or when the edges of
the image cannot be seen.
• For details of the Resize mode, see pages
30 and 31.
• You can also press RESIZE on the remote
control to set the Resize mode. (See page 30.)
Note
2
Adjusting the Image
Position
You can move the projected image vertically.
Q buttonO button
• This function only works in some Resize
modes. (See pages 30 and 31.)
Note
3
Keystone Correction
When the image is projected either from the top
or from the bottom towards the screen at an
angle, the image becomes distorted trapezoidally.
The function for correcting trapezoidal distortion
is called Keystone Correction.
Select “Keystone” on the “SCR-ADJ”
menu and adjust with the slide bar.
See page 28 for details of Keystone Correction.
O buttonQ button
• The Keystone Correction can be adjusted up to
an angle of approximately ±40 degrees (When
the Resize mode is set to “NORMAL”).
• You can also press KEYSTONE on the
remote control to adjust Keystone Correction.
Note