Sharp Plasmacluster IG-A20U User Manual

ENGLISH
FRANÇAIS
ESPAÑOL
E-9
OPERATION
Open the cover of the operation panel.
The operation cover is fi xed with a screw.
To open the cover, remove the rubber cover,
then the screw and washer.
Fix the cover of the operation panel.
If necessary, screw down the cover with the provided
screw and washer and replace the rubber cover.
(Please see Page E-7)
Operation
panel
Press the operation button to select the preferred mode.
LOW
Release high-density
Plasmacluster ions quietly.
MED
Release high-density
Plasmacluster ions at medium fan
speed.
HIGH
Release high-density
Plasmacluster ions at high fan
speed.
Power 'OFF'
OPERATION BUTTON
AUTO RESTART
If the AUTO RESTART switch is set to "ON"
and the unit is accidently unplugged, the
circuit breaker trips of there is a power failure,
the unit will automatically start operation at the
previous setting after power is restored.
AUTO RESTART
Switch
This operation manual is based on IG-A40U.
The operation is also the same as IG-A20U.
IG-A20UA40U.eng.indd11IG-A20UA40U.eng.indd11 2010/09/2915:31:172010/09/2915:31:17

Sharp Plasmacluster IG-A20U Specifications

General

Brand	Sharp
Model	Plasmacluster IG-A20U
Category	Air Cleaner
Language	English