PN-465U CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTION
2 – 36
4) Click [RUN] button and check to confirm that “PN-465 Temperature”
is booted.
5) Select the connected port with “COM Port”.
6) Click [RESET] button to execute resetting.
7) Resetting is completed after a while. Check to confirm that all tab
items are as shown in the figure below. If there is any “ERR” item,
press [RESET] button to execute resetting.
9-3. NOTE FOR USING THE TEMPERATURE MONI-
TOR SETTING TOOL
When an error massage is indicated on the display, check the following
items.
• When “Command Sending Retry Error” and “Nothing Received” are
displayed:
Check to confirm that the PC and the information display are prop-
erly connected with the RS-232C cable.
• When “COM Port Open Error” is displayed:
Check to confirm that the set COM Port is not used by another tool. If it
is used by another tool, terminate the tool, and execute the procedures
again.
To Next Page
Loading...
