Sharp PN-CD701-LCD

8
E
Turning Power On/Off
Caution
• Turnonthemonitorfirstbeforeturningonthecomputeror
playbackdevice.
• WhenswitchingthemainpowerswitchorthePOWER
buttonoffandbackon,alwayswaitforatleast5seconds.
Ashortintervalmayresultinamalfunction.
• Tokeeptheperformance,putthemonitorinthePoweroff
stateonceaday.
Turning on the main power
Main power switch
Caution
• Themainpowermustbeturnedon/offwiththemainpower
switch.Donotconnect/disconnectthepowercordorturn
thebreakeron/offwhilethemainpowerswitchison.
• Foracompleteelectricaldisconnection,pulloutthemain
plug.
Turning power on
PressthePOWERbuttononthismonitortoturnthepower
ON.
Power LED / POWER button
Status Status of the monitor
Whitelit Poweron
Amberlit Poweroff
n
Operations after first power-on
Whenthemonitoristurnedonforthefirsttimeafterbeing
shippedfromthefactory,thesettingscreenwillbedisplayed.
Configurethesettingsaccordingtothescreen.
About Operation Mode
Mode1:
• Thismonitorgoesintostandbymodewhenthereisno
operationfor4hours.
• Powerconsumptioninstandbymodeisalsominimized.
Mode2:
• Willperformstandardoperation.
• Thismonitordoesnotgointostandbymodeevenifno
operationcontinues.
• Powerconsumptioninstandbymodeincreases.
Turning power off
Power LED / POWER button
When “Operation Mode” is set to “Mode1”
PressthePOWERbuttontoturnthepowerOFF(standby
mode).
When “Operation Mode” is set to “Mode2”
WhenyoupressthePOWERbutton,thebrightnesswillbe
reduced.
ToturnthepowerOFF(standbymode):
1. Long press the POWER button.
 Therecognitionscreenappears.
2. Touch [STANDBY].
 Thepoweristurnedoff(standbymode).